Views: 0 Author: Site Editor Publish Time: 2020-10-21 Origin: Site
Mylar forming machine is used for forming the polyester film. The procedures include feeding, pre-forming, heating, forming, cutting and discharging etc. Conductor width, heating temperature, cutting length and formed quantity etc can be set on machine in advance so the equipment can adjust automatically. But do you kow what is mylar forming machine?let’s read the article.
The article contains following：
1,Assembly environment requirements of mylar forming machine
2，Main analysis of main fault handling methods of mylar forming machine
3,Treatment method of mylar forming machine
The assembly of dense busbars requires a relatively dust-tight environment. The polyester film forming machine and the work surface must be clean and dust-free, and all semi-finished products must be wiped clean before entering the assembly area. The polyester film forming machine manufacturer enters the assembly area. Change shoes and work clothes in the area, otherwise too much dust will increase the leakage current of the bus and reduce the insulation resistance;
First, the power failure of the sliding contact line
The main reasons: the brush is climbing in the conductor; the brush is severely worn, and the polyester film forming machine cannot touch the conductor; the conductor joint is uneven; the single current collector is used; the rail joint is loose.
Treatment method: check whether the current collector brush is severely worn, replace the current collector brush; replace the brush to re-adjust the connection node; use the double-brush current collector; re-adjust and tighten the connection screw.
Second, the guide rail is deformed and the operation of the collector is blocked
The main reason: the ambient temperature is too high; the distance between the lifting racks is large or loose.
Treatment method: Partially use heat insulation board, and add sun visor outside; increase the number of sliding contact wire hangers, correct the conductor and tighten the screws.
Third, the cable slippery line shakes greatly when working
The main reasons: the fork cannot absorb the transmission error; the straightness of the guide rail is poor; the lifting frame is loose.
Treatment method: correct the tractor so that it can freely absorb the transmission error; adjust the straightness of the guide rail.
Fourth, the brush wears quickly
Main reasons: uneven joints; excessive current carrying capacity; high spring pressure.
Treatment method: reconnect the guide rail as required; increase the number of collectors; replace and modify the spring pressure.
Inspection of dense bus:
Because of the structural characteristics of the intensive bus, its factory inspection is particularly important. Each functional unit must be strictly inspected before it can be put into the warehouse. Products that fail to pass the inspection must not be put into the warehouse. In addition to the appearance inspection requirements for the installation of air-type busbars for dense busbars, the polyester film forming machine equipment, it is important to conduct a busbar i withstand voltage test at 3750V for 1min for each unit, and only qualified products can be imported In the warehouse, the unqualified products are returned to the assembly process, the fault point and the cause of the fault are found after disassembly, and the withstand voltage test is performed again after the rework treatment, and the product can not be put into the warehouse until it is qualified. We also provide 3 in 1 busbar machine, mylar film slitting machine, click us now!
